This sample consists of a Studio project containing a single module file intended to illustrate a few basic features of EventFlow Debugger breakpoints.
The application is a simple design with two branches. Tuple flow depends on the value of the
branch field you provide for input tuples in the Test/Debug perspective. Sending
top routes that tuple into the OutBranchTop output stream. Any other value for
branch sends tuples to the OutBranchBottom stream.
Before you run the sample, you must create some breakpoints at which to stop during execution. You can add a breakpoint to any arc by selecting it and then either by right-clicking and selecting Ctrl+Shift+B. When you add a breakpoint, a round dot appears on the arc to indicate it.from the context menu or by typing
For more information on debugging in StreamBase Studio, see Using the EventFlow Debugger.
In StreamBase Studio, import this sample with the following steps:
From the top-level menu, click> .
breakto narrow the list of options
Select Setting breakpoints from the Applications category.
StreamBase Studio creates a project for the sample.
In the Project Explorer view, open the sample you just loaded.
If you see red marks on a project folder, wait a moment for the project to load its features.
If the red marks do not resolve themselves after a minute, select the project, right-click, and select> from the context menu.
Double-click to open
Place a breakpoint on the top arc between the Sequence and NoOp operators, as described above.
Place another breakpoint on the bottom arc between the Sequence2 and NoOp2 operators.
Make the bottom breakpoint conditional by following these steps:
Right-click the bottom breakpoint and selectfrom the context menu.
3in the field next to it.
Click the button. This opens the SB Test/Debug perspective and starts the module in debugging mode.
In the Input Streams view, enter
topin the branch field, any string value in the payload field, and click .
Execution suspends when the top breakpoint receives the tuple, highlighting the tuple's path in blue. Also, the Variables view opens, displaying the tuple's values and dynamic variable and query table values for you to inspect.
To continue execution, click the button or press F8. The tuple flows to the Output stream OutBranchTop and highlighting is removed from the diagram.
In the Input Streams view again, replace
topin the branch field with any other string, enter any string value in the payload field, and click .
The debugger does not activate until you send data three times to the lower branch. Then the data path to the lower breakpoint highlights and the Variables view again displays data values.
If you resume execution and continue to send tuples to the lower branch, its breakpoint does not activate again, because you configured it to respond to the third tuple only. However, the next time you debug the application, the breakpoint resets and once again halts execution at the third tuple.
When done, press F9 or click the Terminate EventFlow Fragment button.
When you load the sample into StreamBase Studio, Studio copies the sample project's files to your Studio workspace, which is normally part of your home directory, with full access rights.
Load this sample in StreamBase Studio, and thereafter use the Studio workspace copy of the sample to run and test it, even when running from the command prompt.
Using the workspace copy of the sample avoids permission problems. The default workspace location for this sample is:
See Default Installation Directories for the default location of
studio-workspace on your system.