This topic describes how to use the EventFlow Editor, which you use to design EventFlow modules. By default, TIBCO StreamBase Studio™ places the EventFlow Editor in:
-
The top middle of the SB Authoring perspective.
-
The middle of the right side of the SB Test/Debug perspective.
To view or change preference settings for the EventFlow Editor, select > from the main menu (Windows) or > (macOS), then >. Preference options are described in Studio Preference Settings.
To open a module into the EventFlow Editor, double-click a module file with
.sbapp extension in a project folder in the Project Explorer view. You can also
double-click an .sblayout file to open the associated
.sbapp file.
To create a new EventFlow module file, use >>.
The EventFlow Editor has seven tabs on the bottom, each described on its own page, as listed in the Contents above.
The names of the bottom tabs are shown in bold if that tab has any content or changes from the default (other than the Editor bottom tab, which presumably always has content). The following example shows the Editor tab active, but you can see at a glance from the bold font that:
-
There is at least one constant or schema definition or import in the Definitions tab.
-
There are custom settings on the Annotations tab.
-
There is either a module description or a custom icon set in the Metadata tab.
|
Contents
- EventFlow Editor Canvas
- EventFlow Editor Command Reference
- EventFlow Editor Keyboard Shortcuts
- EventFlow Editor Definitions Tab
- EventFlow Editor Parameters Tab
- EventFlow Editor Dynamic Variables Tab
- EventFlow Editor Typecheck Options Tab
- EventFlow Editor Annotations Tab
- EventFlow Editor Metadata Tab
- EventFlow Editor Read-Only Canvas